Skip to main content
On this page · 7 sections
  1. List every part
  2. Turn finished sizes into blank sizes
  3. Set grain direction
  4. Nest parts on sheets
  5. Label every part
  6. Check before you cut
  7. See a real one

How to Make a Cabinet Cut List and Sheet Layout

From a drawing to labeled parts on the saw

CabinetBuilder.ai · Updated · 9 min read

Quick answer: A cabinet cut list names every part with its cut size, material, grain direction and banded edges. A sheet layout places those parts on whole sheets so the saw operator knows what to cut from each one. Work from finished sizes, subtract banding to get blank sizes, keep grain running the right way on visible parts, allow for the saw kerf, and label every part so assembly does not depend on memory.

A cut list turns a cabinet drawing into the parts a saw can cut. Done by hand it is slow and error-prone; one wrong number shows up as a box that does not close. The steps below are the same whether you do it on paper, in a spreadsheet or in software.

List every part

Go cabinet by cabinet and write down every part: sides, bottom, top or stretchers, back, shelves, toe kick, drawer box parts, and doors and drawer fronts if you make them. For each part, note:

  • the cabinet it belongs to,
  • the part name,
  • the material and thickness,
  • the finished width and length.

Group parts by material. Your saw operator cuts all the ¾″ maple plywood before switching to ¼″ backs, so the cut list should be grouped the same way.

Turn finished sizes into blank sizes

The finished size is what the part measures in the cabinet. The blank size is what you cut. The difference is edge banding: if a shelf gets 1 mm banding on its front edge, you cut it 1 mm narrower so the banded shelf comes out at its finished size.

Mark which edges get banded on every part. A cut list without banding marks is the most common reason parts come out of the bander a hair too big.

Set grain direction

On anything visible (exposed ends, doors, drawer fronts, open shelves) the grain should run the same way, usually along the length of the part. Mark grain direction on the cut list. Parts with grain locked cannot be rotated on the sheet to fit, so they limit how tightly you can nest.

Nest parts on sheets

A sheet layout, also called a cutting diagram or nest, places parts on whole sheets. Good layouts:

  • trim a clean factory edge off each sheet first,
  • leave a kerf (the width of the saw blade, often around ⅛″) between parts,
  • keep grain-locked parts in their direction,
  • cut long rips first so the sheet breaks down into strips you can crosscut,
  • keep usable offcuts in one piece rather than scattered slivers.

The sheet count from the layout is what you buy and what you price. See how to price a cabinet job.

Label every part

Write the cabinet and part name on each part as it comes off the saw. A label with the cabinet number, part name and banded edges lets anyone in the shop assemble the job without the drawing in hand. Stacking labeled parts by cabinet saves a sort later.

Check before you cut

  • Count sides: every base and upper has two, and an end panel may add a third.
  • Check that drawer box widths match the slide clearance your slides need.
  • Check that the sheet count matches the material you have.
  • Re-read banding: one missed edge is one more trip to the bander.

See a real one

Open the galley kitchen example for a full sample shop pack: elevations, sheet layouts and the cut list grouped by material. The reach-in closet example shows the same for three wardrobe units in prefinished birch.